▲▼
▲
▼
While the multi-information display
is in the METER SETUP of the
CUSTOMIZE GROUP, press the
SEL/RESET button. The screen
changes to CUSTOMIZE MENU.
Press the INFO ( / ) button until
you see the above display.
Press the SEL/RESET button. The
screen changes as shown above. The
highlighted number is the current
setting above or below the outside
temperature. Press the INFO ( /
) button repeatedly until the
number you want appears, then
press the SEL/RESET button to
enter your selection.
If you sometimes find that the
temperature reading is a few
degrees above or below the actual
temperature, you can adjust it by
following these instructions:
Multi-Information Display
Adjust Outside Temp. Display
94
To Next Page
Loading...
