Page 3 of 13
2. When the indicator blinks, touch the keyless remote to the ENGINE START/STOP button.
The indicator will switch from blinking to steady when communication is complete.
3. Start the engine by pressing the ENGINE START/STOP button while pressing the brake pedal. You must start
the engine within 10 seconds of touching the remote to the button.
1. Remove the Exterior Protective Coatings
Carefully remove all of the exterior protective coatings. See S/B 96-009, Removal of Protective Coatings During TQI.
2. Install the Fuses
To prevent battery drain during vehicle shipping, the No. 15 RADIO (20 A) fuse (except Advance Package models with
Auto Idle Stop) and the No. 16 BACKUP (10 A) fuse are removed from the main under-hood fuse box and stored in the
glove box. Make sure the ignition is turned to OFF before installing these fuses.
To Next Page
Loading...
