Lights
Replacing a Rear License Bulb
1. Use a Phillips-head screwdriver to
remove the two screws holding
the license plate light assembly to
the bracket. Pull the assembly
away from the bracket.
2. Remove the socket from the light
assembly by turning it one-quarter
turn counterclockwise.
3. Pull the bulb straight out of the
socket.
4. Install the new bulb in the socket.
5. Turn on the parking lights and
make sure the new bulb is
working. Reinstall the license plate
assembly on the bumper bracket
with the same two screws.
Maintenance
To Next Page
Loading...
