4. Install the Floor Mats
Install the floor mats in the appropriate positions. Place the driver’s and front passenger’s floor mat eyelets over the
anchors on the floor, then turn the knobs clockwise to the lock position. Do the same for the rear seat floor mats.
The anchors for those mats are under the front seats.
Under-Hood (Engine Cold)
5. Check the Battery
To ensure long battery life and that the client gets a fully charged battery, it must be checked at these times:
• When the vehicle first arrives at the dealership
• During the TQI, if done at a later date
• At regular intervals
• Just before vehicle delivery
The positive battery terminal has a plastic cover. To avoid breaking it, open the cover as shown:
Test the battery with the ED-18 battery tester using S/B 88-016, Battery Testing and Replacement. Make sure the
ED-18 has the latest software installed before using it. See S/B 09-027, ED-18 Battery Tester Update Information.
If the test results show GR8 DIAGNOSTIC NEEDED, you must charge the battery with the GR8 battery diagnostic
station. Make sure the GR8 has the latest software installed before using it. See S/B 09-034, GR8 Battery Diagnostic
Station Update Information.
Write down the GOOD BATTERY 10-digit code in the maintenance journal. During the TQI, write down the code in the
“Under Hood (Engine Cold)” section. Then, at vehicle delivery, write it down in the “Final Inspection (At Delivery)”
section.
Page 5 of 11
To Next Page
Loading...
