8. Clean the Rear License Plate Area and Install the Mounting Hardware
Remove the masking tape covering the two bolt holes. Using 3M General Purpose Adhesive Cleaner (3M #051135-
08984) and a clean shop towel, carefully remove any tape residue. Then install the mounting hardware as shown.
Vehicle Exterior (Vehicle Lowered to Ground)
9. Set the Tire Pressures
To prevent flat spots during vehicle shipping and storage, the tires are inflated to over 40 psi. Adjust the tire pressures
to the cold inflation values listed on the driver’s doorjamb label. If you are in a cold climate region, make sure the tires
are at the outside ambient temperature before adjusting the pressures; otherwise, the Low Tire Pressure/TPMS
indicator may come on in cold weather.
NOTE: There is no spare tire. This vehicle comes with a tire repair kit stored under the trunk lining. An optional spare
tire can be ordered separately.
10. Initialize the Tire Pressure Monitoring System (TPMS)
If the Low Tire Pressure/TPMS indicator stays on with the power mode set to ON, do this to initialize the system:
1. Start the engine, then turn it off.
2. Wait 25 seconds.
3. Repeat steps 1 and 2 three times.
4. Check the TPMS message in the MID; the tire pressure readings should be normal. If they are abnormally high,
check for DTCs with the HDS.
Page 8 of 11
To Next Page
Loading...
