Under-Hood (Engine Idling)
11. Do the Idle Learn Procedure
To ensure a steady engine idle, do the idle learn procedure as follows after installing the No. 15 BACKUP RADIO (10 A)
and No. 16 BACKUP (10 A) fuses:
1. Make sure all electrical items (A/C, audio unit, rear window defogger, lights, etc.) are turned off.
2. Start the engine, and let it reach operating temperature (the cooling fans cycle twice).
3. Let the engine idle for 10 minutes with the throttle fully closed.
The idle learn procedure must also be done after updating or replacing the PCM. If does not need to be done after
clearing DTCs.
Vehicle Interior
12. Install the Shift Lock Release Cover
Install the shift lock release cover into the shift lock release slot. This slot is under the center console lid behind the shift
lever. Install the cover with its notch facing the driver’s side of the vehicle.
13. Initialize the Audio-Navigation Unit Anti-Theft Function, and Set the AM/FM Audio Unit Presets
Follow these steps to initialize the anti-theft function and set the audio unit presetss:
1. Do S/B 15-008, 2016 RLX: TQI of the Navigation System.
2. Enter a local AM or FM station on all of the audio unit presets (AM, FM1 and FM2). To enter a station, tune to it,
change the screen to the preset screen, then press and hold the preset number that you want to store that
station.
14. Check/Refresh the XM Satellite Radio Dealer Demo Service (Except in Alaska and Hawaii)
The audio system comes from the factory activated with the XM Satellite Radio dealer demo service. Once you install
the No. 15 BACKUP RADIO (10 A) and No. 16 BACKUP (10 A) fuses, the XM radio should receive the full range of
available XM channels. You can see a full list of channels at siriusxm.com.
While watching the audio unit display, tune to several channels within the full XM lineup. If you can tune to all of the XM
channels, the dealer demo service is activated.
Page 9 of 11
To Next Page
Loading...
