Adance ADE-2022-C - Page 7

ADE- 2022-C Page 7 of 50
To Blast Chill
To Blast ChillTo Blast Chill
To Blast Chill
1. To stop the cycle push and hold the START/ STOP button until
the yellow light turns off.
2. Push and release the button until the desired cycle is selected.
The cycle number selected will be highlighted.
Cycle
CycleCycle
Cycle
Blast
Blast Blast
Blast
mode
modemode
mode
1
11
1
st
stst
st
Phase
Phase Phase
Phase -
--
- Hard Chill
Hard ChillHard Chill
Hard Chill 2
22
2
nd
ndnd
nd
Phase
Phase Phase
Phase -
--
- Soft Chill
Soft ChillSoft Chill
Soft Chill
Total
Total Total
Total
cycle
cycle cycle
cycle
duration
duration duration
duration
(min)
(min)(min)
(min)
Duration
(min)
Temperature
(°C)
Duration
(min)
Temperature
(°C)
1
11
1 Soft Chill 90 -1 90
2
22
2 Hard Chill 60 -15 30 -1 90
3
33
3 Soft Chill 120 -1 120
4
44
4 Hard Chill 80 -15 40 -1 120
3. Push and release the START/ STOP button the yellow light will
be switched on indicating that the blast chill cycle has started.
Normal Operation
Normal OperationNormal Operation
Normal Operation
For normal refrigeration or frozen storage
normal refrigeration or frozen storagenormal refrigeration or frozen storage
normal refrigeration or frozen storage push button until the ‘H’
‘H’‘H’
‘H’
appears on the display and no cycle numbers are lit.
To change temperature push and release the button this will show the current
set point.
Then push and hold down the button and the word “SetH”
“SetH”“SetH”
“SetH” will flash
Use the and buttons to either increase or decrease the set point
temperature.
Push the button again to store the new set point. If the set button is not
pressed the temperature will revert back to previous setting.
Press to activate the hold mode, the buttons and will be
illuminated.