# Default-Stop: 0 1 6
To activate the changes, execute 'insserv stor_agent', as root.
--------------------------------------------------------------------
3. Adaptec Storage Manager General Cautions and Notes
3.1 General Cautions
- This release supports a maximum of 8 concurrent online capacity
expansion (OCE) tasks in the RAID array migration wizard.
- While building or clearing a logical drive, do not remove and
re-insert any drive from that logical drive. Doing so may cause
unpredictable results.
- Do not move disks comprising a logical drive from one controller
to another while the power is on. Doing so could cause the loss of
the logical drive configuration or data, or both. Instead, power
off both affected controllers, move the drives, and then restart.
- When using Adaptec Storage Manager and the CLI concurrently,
configuration changes may not appear in the Adaptec Storage
Manager GUI until you refresh the display (by pressing F5).
3.2 General Notes
- Adaptec Storage Manager requires the following range of ports
to be open for remote access: 34570-34580 (TCP), 34570 (UDP),
34577-34580 (UDP).
- Adaptec Storage Manager generates log files automatically to
assist in tracking system activity. The log files are
created in the directory where Adaptec Storage Manager is
installed.
o RaidEvt.log - Contains the information reported in
Adaptec Storage Manager event viewer for all
local and remote systems.
o RaidEvtA.log - Contains the information reported in
Adaptec Storage Manager event viewer for the
local system.
o RaidNot.log - Contains the information reported in the
Notification Manager event viewer.
o RaidErr.log - Contains Java messages generated by
Adaptec Storage Manager.
o RaidErrA.log - Contains Java messages generated by the
Adaptec Storage Manager agent.
o RaidCall.log - Contains the information reported when
statistics logging is enabled in ASM.
Information written to these files is appended to the existing
files to maintain a history. However, when an error log file
reaches a size of 5 Mbytes, it is copied to a new file with
the extension .1 and the original (that is, the .LOG file) is
deleted and recreated. For other log files, a .1 file is created
when the .LOG file reaches a size of 1 Mbyte. If a .1 file already
exists, the existing .1 file is destroyed.
- In the Event viewer, Adaptec Storage Manager reports both the
initial build task for a logical drive and a subsequent Verify/Fix
as a "Build/Verify" task.
- When displaying information about a physical device, the device,
vendor and model information may be displayed incorrectly.
4
To Next Page
Loading...
