Note: When alarm is sounding, press the / NAP or RADIO /
SLEEP will activate the nap timer or the radio and stop the alarm
for the day.
SNOOZE OPERATION (default snooze duration is 5 minutes)
When alarm is sounding, presses once, the alarm will be
silenced and come on again after the set snooze duration.
Note: if your second alarm activates while the rst alarm is soun-
ding or it is in the snooze mode, the second alarm overrides the
rst alarm (the rst alarm is reset to come on the next day).
USING THE HI-LO DIMMER
Press to adjust the brightness of the LED display. This can
only be done when the radio is o or the unit is not sounding.
USING THE NAP TIMER
The NAP Timer allows you to rest and automatically wake up in
5, 15, 30, 45, 60,75 or 90 minutes.
1. Press / NAP once, the display shows the nap icon and the
default naptime “05” (5 minutes).
2. Press / NAP again to select your desired naptime. It will
exit to time display if no button pressed for 5 seconds.
3. The nap icon lights up when the nap timer is counting. When
the nap timer reaches 0, the alarm will sound and the nap icon
will ash. Press / NAP once to stop the nap alarm , the nap
icon will go o.
Note: If the nap time is set up while your alarm is sounding,
your nap time will be cancelled automatically.
SETTING UP THE FM ANTENNA
Extend the FM wire antenna fully and vary the direction for best
FM reception. Do not strip, alter or attach to other antennas.
LISTENING TO THE FM RADIO
1. To turn on the radio, press SLEEP/RADIO once, the display
shows “ON” and then the radio frequency readings in Mhz.
2. Press / to tune the radio to a desired station. Press and
hold / to scan for the next clear station.
3. To adjust the volume, press VOL once, the display shows
“L07”, press / to adjust volume from L01 (minimum) to
L15 (maximum)
4. Press to turn o the radio.
Note: keep your radio away from uorescent lamps or other
electronic devices, which may cause interference to the radio.
To Next Page
Loading...