Level it back and forth. Then level it side to side. Not at any time should you place the
appliance on top of an inflammable surface (such as: table cloth, carpet, etc.). You must not
locate the appliance near open fireplaces, electric ovens, electric heaters or other heat
sources. Position the device appropriately so that the plug is always accessible. Make sure
liquids enter neither the electrical system nor the switch. Dry off the device thoroughly! If
the oven holder is selected by clients, when installation proceeds, each part should be fixed
firmly. The available voltage and frequency should be the same as that indicated on naming
plate. A fuse breaker and main switch should be fixed upstream of the power connection.
The equip-potential grounding screw should be grounded safely with copper wire whose
cross section area is larger than 2.5 ㎜
2
The working temperature should range from 0℃ to 35℃. The humidity should be lower
than 85%
5.3 Operating
This product has heating elements both at the top and the bottom parts. Heating elements
will give off heat when pizza is passed from one end to the other. This would assure the best
baking result of pizzas.
S/N Description S/N Description
1 LED indicator 7 Anti-clockwise rotation
2 Power on/off 8 Decrease of speed
3 Temperature/voltage setting 9 Increase of speed
4 Increase of value 10 Display of speed value
5 Decrease of value 11 Bottom power input
6 Clockwise rotation 12 Top power input
Note: Top& bottom power input is adjusted by adjusting the value of voltage
input. The higher of input power value, the higher the inside temperature, vice
To Next Page
Loading...