Why is the ADIATEK Blower squeegee not drying perfectly?
To resolve streaks left by the ADIATEK Blower, ensure the squeegee rubbers are clean and that the suction hose is correctly connected to both the recovery tank and the squeegee bar. Also, check and clean the suction filter. Replace the rubbers if they are worn. Confirm that the suction motor switch is activated. Finally, check the level in the recovery tank and empty it if necessary.
How to improve cleaning performance of ADIATEK Blower?
If the ADIATEK Blower is not cleaning effectively, ensure you are using original brushes with the correct bristle dimensions. Increase the solution flow by opening the solution flow adjuster. Also, verify that the liquid detergent concentration is at the recommended percentage.
What to do if ADIATEK Blower has insufficient water on the brush?
To address insufficient water flow on the brush of your ADIATEK Blower, first, check that the solenoid valve switch is activated. Next, check the liquid level in the solution tank. Ensure the solution flow adjuster is sufficiently open and that the brush control levers are pressed. Finally, inspect the solution filter to ensure it is clean.
How to troubleshoot suction motor not working on ADIATEK Blower?
If the suction motor of your ADIATEK Blower isn't working, check the battery charge level. Verify that the suction motor switch is activated by checking if its green signal lamp is on. Also, check the level in the recovery tank and empty it if needed.
To Next Page
General