Admiral RX1000 - User Manual

Admiral RX1000 10-Channel DSMX™ !
Compatible Receiver!
with Diversity Antenna
Quick Start Guide


Page 1
Identifying the RX1000’s Ports
The RX1000 has 12 ports. BIND is for the Binding/Fail-
Safe process; the unlabeled port is for configuring the
receiver for high-speed, digital servos. AUX1-AUX5 are
for surfaces or other controls, such as flaps or gyro
control. The rest are labeled with their intended
channels, but they can be used for other purposes.
Auxiliary 1-5
Bind
Throttle
Aileron
Elevator
Rudder
Gear
Binding the RX1000
To bind the RX1000 to your transmitter, perform the following steps:"
1. Insert the Bind plug onto the BIND port."
2. Connect the receiver to power, such as
connecting an ESC’s throttle lead to the
THRO port and a battery to the ESC. The
receiver’s Bind Mode light (located on the
bottom) flashes quickly, indicating it is in
Bind mode."
3. Turn on your transmitter and put it in Bind
mode. Usually, this involves holding a
switch or button (such as the Trainer switch)
while turning the transmitter on. (See the
instructions for your transmitter for the
details.)"
4. When the red Bound light (located on the
bottom of the receiver on the side opposite
to the ports) illuminates, release the Bind
switch or button on the transmitter. The
RX1000 is bound to the transmitter."
5. Remove power from the receiver."
6. Remove the Bind plug from the receiver."
7. Turn off the transmitter."
Test the connection by turning on the
transmitter and then powering the receiver. The
Bound light should illuminate."
Always perform a range test before flying the
model. See the instructions for your transmitter for the
details."
Bind for High-
Speed Servos
Auxiliary 1-5
Bind Mode
Light
Bind Plug
Bound Light

Summary

RX1000 Receiver Identification and Binding

Identifying the RX1000 s Ports

Details the function and labeling of the 12 ports on the RX1000 receiver for various controls and functions.

Binding the RX1000 to Transmitter

Step-by-step instructions for binding the RX1000 receiver to a compatible transmitter.

RX1000 Connections and Configuration

Connecting Servos to the RX1000

Guide on connecting servos, ESCs, and retracts, noting control wire orientation.

Setting the RX1000 s Fail-Safe

Procedure to set fail-safe positions for controls in case of signal loss.

Configuring for High-Speed Digital Servos

Steps to optimize the receiver for high-speed (11ms) digital servos for peak performance.

RX1000 Installation and Usage

Installing the RX1000

Recommendations for mounting the RX1000 and positioning antennas for signal reliability.

Using a Satellite Receiver

Instructions for connecting and utilizing a satellite receiver for improved signal reception.

RX1000 Notes and Specifications

Key operational notes, including canceling high-speed mode, and technical specifications.

Admiral RX1000 Specifications

General

Brand	Admiral
Model	RX1000
Category	Receiver
Language	English