05
Precautions before riding
Dear users, for your safety and to prevent safety accidents, please do the following checks before
riding. If there is any abnormality，please repair it in time or find a professional repair!
(1)Inspection of power supply circuit and lighting circuit:
Check whether the power supply circuit, lighting circuit and device are damaged; Turn on the
power supply, operate the lighting switch, check whether the headlights and taillights are on, and
whether the brightness of the headlights and taillights is normal;
Check the front and rear brake handlebars respectively to check whether the stop lamp is on
and whether the motor is powered off;
Operate steering lamp switch to check whether the steering indicator and turn signal are
working properly.
(2)Check of brake device:
Check whether the front and rear brakes can work normally; Check the braking effect of the
front and rear brakes to ensure that the brakes are normal and effective;
Confirm whether the power-off switch is normal when the rear wheels are off the ground with
double support of the whole vehicle;
Please check the fastening status of each axle to ensure that the front and rear axles and
handlebars are fastened reliably.
(3)Check the fastening status of handlebar and front and back wheels:
Shake the handlebar up, down , front, back, left and right to check whether it is loose or
pongee;
Shake left and right front and back wheels to check whether there is looseness; whether the
rotating wheel is too tight or stuck.
(4)Tire inspection:
Check whether the tire pressure is normal. Judge whether the air pressure is appropriate
according to the depression of the ground part of the tire. When the air pressure is abnormal, use
the tire pressure measuring instrument to check and adjust it to the normal air pressure;
whether the tire has cracks or abnormal wear;
Whether the tire is embedded with nails, stones and glass;
When the tire is used to the tread wear mark, the tire should be replaced.
(5)Inspection of reflector and license plate:
Check whether the reflector is missing. If it is found missing, contact the after-sales service
immediately to reassemble the reflector of the same specification and model, and the installation
position should be consistent with the original bicycle .Please do not change the position, modify,
disassemble, etc. privately.
Before each use, check that the function of the reflector is normal and the surface of the
reflector is kept clean.
The Reflector device cannot be blocked by luggage, children chair, clothes and other objects,
otherwise it will cause potential safety hazards.
Check whether the license plate is installed firmly, whether the number is clear, whether there
is any damage or pollution, and if there is any should, reinforce, clean or replace it in time.
Before each ride, please make sure that the following items: whether the frame lock，vertical
tube lock, seat tube locking fastener are locked, whether the brake system is normal, and the
tires are full of gas to ensure riding safety!
To Next Page
Loading...