ADT Safewatch Quick Connect Plus - Page 3

Security Codes
You can program up to 6 additional user codes.
 To add a user, enter the [Master code] + [CODE] + [new user number] + [new user code].
 To erase a user, enter the [Master code] + [CODE] + [user number] and wait approximately three
seconds for the keypad to beep and verify.
Some user numbers have already been programmed:
Pre-programmed User
Function
User Number
Installer
All functions
[1]
Master
All functions
[2]
Babysitter
Only arm the system.
[7]
Duress
Secretly notifies the
monitoring center of duress.
[8]
For a complete list of User Code Attributes, please see the Safewatch Quick Connect Plus system manual.
Trouble Conditions
When a trouble condition is detected, the word ‘FAULT’ will be displayed on the panel.
 The existing Trouble Condition keyword will appear on the display.
 To silence the Trouble Condition beeps, enter your [security code] + [OFF].
For a list of possible Trouble Conditions, please see the Safewatch Quick Connect Plus system manual.
Volume
System announcements and status beep volume can be adjusted.
 To adjust the volume level, press [FUNCTION] + [VOLUME] + [3]/[6].
 [3] increases the volume by one level and [6] decreases the volume by one level.