SNMP in the NetVanta 1570 Configuring SNMP Using the CLI
6AMCCG0018-29A 9
4. Configuring SNMP Using the CLI
Configuration of SNMP in the NetVanta 1570 consists of retrieving the ASE MIBs needed for the network and
enabling and configuring the device to be polled by a NMS. The NetVanta 1570 can be configured using SNMP
v1/v2c or SNMP v3 security.
Retrieve the ASE Product-Specific MIBs
Before you begin configuration, download the MIBs you want to install on your NMS. Retrieve the NetVanta
1570 MIBs,on Adtran’s website at the following link:
https://supportcommunity.adtran.com/t5/General-MIBs/bd-p/sw-general-mibs. Select NetVanta 1570 (ASE) to
initiate a download of a zip file containing the NetVanta 1570 MIBs.
After downloading the MIBS, connect to the ASE CLI and begin configuring SNMP in the ASE device as
outlined in the following sections:
● Configuring SNMP Using v1/v2c on page 9
● Configuring SNMP Using v3 on page 11
● Optional Settings for SNMP v1/v2 and v3 on page 14
Configuring SNMP Using v1/v2c
The following steps detail the CLI commands used to enable SNMP management on the NetVanta 1570 for
SNMP v1/v2c:
Step 1: Enable SNMP on the ASE Device on page 9
Step 2: Enter Your SNMP Community Secret on page 10
Step 3: Enable the SNMP security Models (firmware v20.12-4 and earlier) on page 10
Step 4: Enable the Read and Write Community on page 11
To begin configuring SNMP in the ASE device using the CLI, connect to the ASE CLI and follow the steps
outlined in the following sections.
Step 1: Enable SNMP on the ASE Device
Use the snmp-server command to enable the SNMP engine on the NetVanta 1570:
(config)#snmp-server
NOTE
g
By default, SNMP is disabled on all ASE switches for security purposes. Adtran recommends
configuring the ASE device with SNMP v3 security, if possible.
To Next Page
Loading...
Need help?
General
