Aduance i-tec - Use and Charging; Supported Batteries and Configuration; Connecting and Initializing; Battery Insertion and Polarity

USE / CHARGING
Charger charges either 1-4 batteries size AA/AAA or 1-2 batteries size
AA/AAA and 1 battery 9V.
Plug one end of the AC cord into the charger and the other end into the
network. Green LEDs will blink.
Insert the rechargeable batteries into the corresponding slots and make
sure that they are inserted correctly (polarity “+, -”).
If the batteries are inserted correctly and the charger is plugged in, the
corresponding LED lights up and charging is started - an adequate
charging level for AA/AAA and 9V flashes. For AA/AAA, first block lights
at 50% charging level, two blocks at 75% level and all blocks light at
100%. After charging of all charged batteries to 100%, LEDs will remain
lit and charging goes into maintenance mode (20 mA) for max. 2h.
The charger will not work and recharge, if defective or non-rechargeable
batteries (standard or alkaline) are inserted, or they are not inserted
correctly. In this case, no charging appears on the respective LED, it will
only flash and the charging will switch off in 1-2 minutes.
Charging time (approximate data) = Capacity [mAh] : Current [mA]
SPECIFICATIONS
Input voltage: AC 100V-240V, 50/60Hz, 10W; DC 12V/1.5A
Output voltage/current: DC 1.48V/max. 500mA (1x AA = 500mA, 2x AA =
2x 500mA, 3-4x AA = 3-4x 500mA; 1x AAA = 1x 500mA, 2x AAA = 2x
500mA, 3-4x AAA = 3-4x 500mA), 9V/50mA
Length of AC cord: 1 m
Product dimensions: 128 x 75 x 31 mm
Product weight: 108 g
EN
07
ENGLISH
i-tec AA/AAA/9V Battery Charger 4 Channel
Battery type Capacity
Charging time
for 1 battery
Charging time
for 2 batteries
Charging time for
3-4 batteries
AA Ni-MH 1500 mAh 3.6 h 3.6 h 3.6 h
AA Ni-MH 2500 mAh 6 h 6 h 6 h
AAA Ni-MH 800 mAh 1.92 h 1.92 h 1.92 h
9V Ni-MH 280 mAh 6-7 h - -
AA Ni-Cd 1000 mAh 2.4 h 2.4 h 2.4 h
AA Ni-Cd 800 mAh 1.92 h 1.92 h 1.92 h
AAA Ni-Cd 300 mAh 0.72 h 0.72 h 0.72 h