Advantech ADAM-6000 series - I;O Module Configuration

5-3-4 I/O Module Configurations
Digital Input Output Module
Selecting ADAM-6000 Digital Modules includes ADAM-6050/605/6060, user can read following
information from the Utility.
Figure 5-9 Digital I/O Module Configuration
LocationStandard Modbus address. ADAM Ethernet I/O Utility shows the Modbus mapping address of
each I/O channel. (Please refer to chapter 4 to see the address mapping for I/O Modules)
And the addresses will be the indexes for applying into the database of HMI or OPC Server.
TypeData Type of the I/O channel. The data type of Digital I/O modules is always “Bit”.
ValueThe current status on each channel of I/O Module. The value of digital I/O modules could be “0”
(OFF) or “1” (ON).
DescriptionDescribes the channel numbers and I/O types of the specific module.