AIMB-785 Startup Manual 3
JWDT1: Watchdog timer output option
Closed Pins
Result
2-4 NC
4-6 System reset*
* Default
PSON1: ATX, AT mode selector
Closed Pins
Result
1-2 AT Mode
2-3 ATX Mode*
* Default
JUSB
Closed Pins
Result
1-2 *USB +5V_DUAL Power
2-3 USB +5V Power
* Default
The CD disc contains a driver installer program that will
lead you through the installation of various device drivers
needed to take full advantage of your motherboard.
Caution! The computer is supplied with a battery-powered
realtime clock circuit. There is a danger of explo-
sion if battery is incorrectly replaced. Replace
only with same or equivalent type recommended
by the manufacturer. Discard used batteries ac-
cording to manufacturer’s instructions.
This device complies with the requirements in Part 15 of
the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired opera-
tion.
Jumpers and Connectors (Cont.)
AT Mode 1-2 closed *ATX Mode 2-3 closed
Software Installation
Declaration of Conformity
NC 2-4 Closed *System Reset 4-6 Closed
*USB +5 V_DUAL Power USB +5 V Power
To Next Page
Loading...
