MANAGING SWITCH
143
4.11.4 Dual Image
The Dual Image page allows you to setup an active and backup partitions for firmware
image redundancy.
To access this page, click Tools > Dual Image.
Figure 4-115. Tools > Dual Image
The following table describes the items in the previous figure.
The ensuing table for Image Information 0/1 settings are informational only: Flash
Partition, Image Name, Image Size and Created Time.
4.11.5 Save Configuration
To access this page, click Tools > Save Configuration.
Click Save Configuration to FLASH to have configuration changes you have made to be
saved across a system reboot. All changes submitted since the previous save or system
reboot will be retained by the switch.
Table 4-113. Tools > Dual Image
Item Description
Active Image Click the format for the image type: Partition0 (Active) or Partition1
(backup).
Save Click Save to save and keep the new settings.
To Next Page
Loading...