MANAGING SWITCH
68
The ensuing table for STP Port Status settings are informational only: Port, Admin Enable,
Path Cost, Edge Port and P2P MAC.
STP Bridge Settings
The STP Bridge Settings page allows you to configure the priority, forward delay, maximum
age, Tx hold count, and the hello time for the bridge.
To access this page, click L2 Switching > Spanning Tree > STP Bridge Settings.
Figure 4-40. L2 Switching > Spanning Tree > STP Bridge Settings
The following table describes the items in the previous figure.
The ensuing table for STP Bridge Information settings are informational only: Priority,
Forward Delay, Max Age, Tx Hold Count and Hello Time.
The ensuing table for STP Bridge Status settings are informational only: Bridge Identifier,
Designated Root Bridge, Root Path Cost, Designated Bridge, Root Port and Last Topology
Change.
Table 4-38. L2 Switching > Spanning Tree > STP Bridge Settings
Item Description
Priority Click the drop-down menu to select the STP bridge priority.
Forward Delay Enter the variable (4 to 30) to set the forward delay for STP bridge settings.
Max Age Enter the variable (6 to 40) to set the Max age for STP bridge settings.
Tx Hold Count Enter the variable (1 to 10) to designate the TX hold count for STP bridge
settings.
Hello Time Enter the variable (1 to 10) to designate the Hello Time for STP bridge
settings.
Apply Click Apply to save the values and update the screen.
To Next Page
Loading...