Advantech ICAM-500 Series - Enum Cameramode

39 ICAM-500 Programming Guide
Chapter 4 CamNavi2 SDK API Manual
4.3.2 enum CameraMode
get_timestamp_switch()
Get timestamp on output image state.
Returns: int
0: Disable
1: Enabled
pos_zero()
Set lens focusing motor to home.
See also:
focus.Focus.pos_zero()
Control by focus instance.
focus_abs_position()
Get lens focusing motor abs position.
Returns: int
Motor position.
See also:
focus.Focus.position()
Control by focus instance.
class iCam500.CameraMode(value)
Camera device status
Disconnected = 0
Camera disconnected
Connected = 1
Camera connected
Playing = 2
Camera start acquisition
Paused = 3
Camera stop acquisition