ICAM-500 User Manual 28
4.5.8.1 Digital Input and trigger input
There are two digital inputs (Pin 8,9), support debouncer features. The debouncer
feature identifies the valid and invalid input signals via setting the debouncer value
(the minimum period of time for the valid signal). In this way, the circuit will only
respond to the signal that the pulse width is greater than debouncer value
trigger in: default setting debouncer 50 us.
4.5.8.2 Digital output
There are two digital outputs (Pin 10,11), each digital output supports inverter and
can be configured as two different modes, including direct output.
Direct output:
The digital output signal is active when a valid command occurs, and the delay time
can be set as well.
ByPass Mode:
The digital output signal is active when a valid digital input occurs.
To Next Page
Loading...
