Advantech ICAM-500 Series - Project Management; Auto-Run

ICAM-500 User Manual 30
4.7 Project management
ICAM-500 allow user to save camera setting as project and provides auto-run, import
and export function.
4.7.1 Auto-run
ICAM-500 allow user to set up auto run project function while camera boot up. Select
the project and enable auto-run function and ICAM-500 will auto execute the project
while camera boot up.
Figure 4.13 Auto run
Auto Gain Mode/Intensity
Gain
Range(0~24)
Platform Settings
I/O Setting
DI 0/1
Debounce time
Edge Trigger (Rising)
DO 0/1
Output High
Output Low
Programming Mode
Direct Output
Reverse on/off
Delay time (ms)
User-defined LED
Green
Orange
Yellow