ICAM-500 Programming Guide 18
advcam_config_pipeline (cam, **pipe_params)
Camera gstreamer pipeline configuration.
Parameters: params: dict{str, str}
Set pipeline parameters.
‘format’: [‘GRAY8’, ‘YUY2’, ‘BGRA’]. Mono sku only has
‘GRAY8’.
‘acq_mode’: 0 = Continuous, 1 = Software Trigger, 2 =
Hardware Trigger
‘width’: 640
‘height’: 480
‘frame_count’: -1 (-1 = continuous, >0 = frame count)
‘icam500=frame-rate’: 60
‘timestamp’: [0, 1]. Print timestamp on image.
‘pipeline_mode’: [‘default’, ‘simple’]. default mode output
jpeg image format, simple mode output raw image.
See also:
HYPERLINK \l "iCam500.iCam500.config_pipeline()
advcam_open(cam, frame_count=-1)
Open camera device.
Parameters: cam: ABSCamera
Camera instance from get_device_by_name.
frame_count: int
Burst images acquisition.
Returns: str
Device name.
None
Camera cannot open.
advcam_close(cam)
Close camera device.
Parameters: cam: ABSCamera
Camera instance
Returns: int
Close camera status.
0: success
1: camera instance is not existed.
2: camera get an exception.
3: camera is no opened.
advcam_get_capability(cam)
Camera capability information.
Returns: dict
Camera capability map
To Next Page
Loading...
Need help?
General
