Advantech ICR-1601 - Authentication Configuration Window

ICR-1601
133
Full Tunnel
Unchecked by
default
Click Enable box to enable Full Tunnel.
Note: Full tunnel is available only for Site-to-Site specified in Tunnel Scenario.
Remote Subnet
List
A Must fill setting
Specify the Remote Subnet IP address and Subnet Mask.
Click the Add or Delete button to add or delete Remote Subnet setting.
Remote Gateway
1. A Must fill setting.
2. Format can be a
ipv4 address or
FQDN
Specify the Remote Gateway.
Authentication Configuration Window
Item
Value setting
Description
Key Management
1. A Must fill setting
2. Pre-shared Key 8
to 32 characters.
Select Key Management from the dropdown box for this IPSec tunnel.
IKE + Pre-shared Key: user needs to set a key (8 ~ 32 characters).
IKE+X.509: user needs Certificate to authenticate. IKE+X.509 will be available
only when Certificate has been configured properly. Refer to Certificate
section of this manual and also Object Definition > Certificate in web-based
utility.
Manually: user needs to enter key ID to authenticate. Manual key
configuration will be explained in the following Manual Key Management
section.
Local ID
An optional setting
Specify the Local ID for this IPSec tunnel to authenticate.
Select User Name for Local ID and enter the username. The username may
include but can’t be all numbers.
Select FQDN for Local ID and enter the FQDN.
Select User@FQDN for Local ID and enter the User@FQDN.
Select Key ID for Local ID and enter the Key ID (English alphabet or number).
Remote ID
An optional setting
Specify the Remote ID for this IPSec tunnel to authenticate.
Select User Name for Remote ID and enter the username. The username may
include but can’t be all numbers.
Select FQDN for Local ID and enter the FQDN.
Select User@FQDN for Remote ID and enter the User@FQDN.
Select Key ID for Remote ID and enter the Key ID (English alphabet or
number).