Advantech ICR-1601 - Page 150

ICR-1601
150
L2TP Client Configuration
Item Setting
Value setting
Description
Tunnel Name
A Must filled setting
Enter a tunnel name. Enter a name that is easy for you to identify.
Value Range: 1 ~ 32 characters.
Interface
A Must filled setting
Define the selected interface to be the used for this L2TP tunnel
(WAN-1 is available only when WAN-1 interface is enabled)
The same applies to other WAN interfaces (e.g. WAN-2).
Operation Mode
1. A Must filled
setting
2. Always on is
selected by default
Define operation mode for the L2TP Tunnel. It can be Always On, or Failover.
If this tunnel is set as a failover tunnel, you need to further select a primary
tunnel from which to failover to.
Note: Failover mode is not available for the router with single WAN.
L2TP over IPSec
The box is
unchecked by
default
Check the Enable box to activate L2TP over IPSec, and further specify a Pre-
shared Key (8 ~ 32 characters).
Remote LNS
IP/FQDN
A Must filled setting
Enter the public IP address or the FQDN of the L2TP server.