Advantech ICR-1601 - Page 164

ICR-1601
164
To Interface
1. A Must filled setting
2. By default Any is
selected
Define the selected interface to be the packet-leaving interface of the router.
If the packets to be filtered are entering from LAN to WAN then select WAN
for this field. Or VLAN-1 to WAN then select WAN for this field. Other
examples are VLAN-1 to VLAN-2. VLAN-1 to WAN.
Select Any to filter packets leaving the router from any interfaces.
Please note that two identical interfaces are not accepted by the router. e.g.,
VLAN-1 to VLAN-1.
Source IP
1. A Must filled setting
2. By default Any is
selected
This field is to specify the Source IP address.
Select Any to filter packets coming from any IP addresses.
Select Specific IP Address to filter packets coming from an IP address.
Select IP Range to filter packets coming from a specified range of IP address.
Destination IP
1. A Must filled setting
2. By default Any is
selected
This field is to specify the Destination IP address.
Select Any to filter packets that are entering to any IP addresses.
Select Specific IP Address to filter packets entering to an IP address entered
in this field.
Select IP Range to filter packets entering to a specified range of IP address
entered in this field.
Source MAC
1. A Must filled setting
2. By default Any is
selected
This field is to specify the Source MAC address.
Select Any to filter packets coming from any MAC addresses.
Select Specific MAC Address to filter packets coming from a MAC address.
Protocol
1. A Must filled setting
2. By default Any(0) is
selected
For Protocol, select Any to filter any protocol packets
Then for Source Port, select a predefined port dropdown box when Well-
known Service is selected, otherwise select User-defined Service and specify
a port range.
Then for Destination Port, select a predefined port dropdown box when
Well-known Service is selected, otherwise select User-defined Service and
specify a port range.
Value Range: 1 ~ 65535 for Source Port, Destination Port.
For Protocol, select ICMPv4 to filter ICMPv4 packets
For Protocol, select TCP to filter TCP packets
Then for Source Port, select a predefined port dropdown box when Well-
known Service is selected, otherwise select User-defined Service and specify
a port range.
Then for Destination Port, select a predefined port dropdown box when
Well-known Service is selected, otherwise select User-defined Service and
specify a port range.
Value Range: 1 ~ 65535 for Source Port, Destination Port.
For Protocol, select UDP to filter UDP packets
Then for Source Port, select a predefined port dropdown box when Well-
known Service is selected, otherwise select User-defined Service and specify
a port range.
Then for Destination Port, select a predefined port dropdown box when
Well-known Service is selected, otherwise select User-defined Service and
specify a port range.
Value Range: 1 ~ 65535 for Source Port, Destination Port.
For Protocol, select GRE to filter GRE packets
For Protocol, select ESP to filter ESP packets