Advantech ICR-1601 - Page 192

ICR-1601
192
Supported
Versions
1.A Must filled
setting
2.The boxes are
unchecked by
default
Select the version for the SNMP
When Check the v1 box.
It means you can access SNMP by version 1.
When Check the v2c box.
It means you can access SNMP by version 2c.
When Check the v3 box.
It means you can access SNMP by version 3.
Remote Access IP
1. String format: any
IPv4 address
2. It is an optional
item.
Specify the Remote Access IP for WAN.
Select Specific IP Address, and fill in a certain IP address. It means only this IP
address can access SNMP from LAN/WAN side.
Select IP Range, and fill in a range of IP addresses. It means the IP address
within specified range can access SNMP from LAN/WAN side.
If you left it as blank, it means any IP address can access SNMP from WAN
side.
SNMP Port
1. String format: any
port number
2. The default SNMP
port is 161.
3. A Must filled
setting
Specify the SNMP Port.
You can fill in any port number. But you must ensure the port number is not
to be used.
Value Range: 1 ~ 65535.
Trap Period
1.A Must filled
setting
2. The default Trap
Period is 10 minutes
Specify the Trap Period in minutes.
Value Range: 1 ~ 1440.
Save
N/A
Click Save to save the settings
Undo
N/A
Click Undo to cancel the settings
Create/Edit Multiple Community
The SNMP allows you to custom your access control for version 1 and version 2 user. The router
supports up to a maximum of 10 community sets.
When Add button is applied, Multiple Community Rule Configuration screen will appear.