ICR-1601
219
Check Enable box to activate the Capture Filter function.
Define the filter rule with Source MACs, which means the source MAC
address of packets.
Packets which match the rule will be captured.
Up to 10 MACs are supported, but they must be separated with “;”,
e.g. AA:BB:CC:DD:EE:FF; 11:22:33:44:55:66
The packets will be captured when match any one MAC in the rule.
Define the filter rule with Source IPs, which means the source IP address of
packets.
Packets which match the rule will be captured.
Up to 10 IPs are supported, but they must be separated with “;”,
e.g. 192.168.1.1; 192.168.1.2
The packets will be captured when match any one IP in the rule.
Define the filter rule with Source Ports, which means the source port of
packets.
The packets will be captured when match any port in the rule.
Up to 10 ports are supported, but they must be separated with “;”,
e.g. 80; 53
Value Range: 1 ~ 65535.
Define the filter rule with Destination MACs, which means the destination
MAC address of packets.
Packets which match the rule will be captured.
Up to 10 MACs are supported, but they must be separated with “;”,
e.g. AA:BB:CC:DD:EE:FF; 11:22:33:44:55:66
The packets will be captured when match any one MAC in the rule.
Define the filter rule with Destination IPs, which means the destination IP
address of packets.
Packets which match the rule will be captured.
Up to 10 IPs are supported, but they must be separated with “;”,
e.g. 192.168.1.1; 192.168.1.2
The packets will be captured when match any one IP in the rule.
Define the filter rule with Destination Ports, which means the destination
port of packets.
The packets will be captured when match any port in the rule.
Up to 10 ports are supported, but they must be separated with “;”,
e.g. 80; 53
Value Range: 1 ~ 65535.
To Next Page
Loading...
