Advantech ICR-1601 - DIN Rail Clip Installation

ICR-1601
27
Dial-Up Profile
1. A Must filled setting
2. By default Manual-
configuration is
selected
Specify the type of dial-up profile for your 3G/4G network. It can be
Manual-configuration, APN Profile List, or Auto-detection.
Select Manual-configuration to set APN (Access Point Name), Dial
Number, Account, and Password to what your carrier provides.
Select APN Profile List to set more than one profile to dial up in turn,
until the connection is established. It will pop up a new filed, please go to
Basic Network > WAN & Uplink > Internet Setup > SIM-A APN Profile
List for details.
Select Auto-detection to automatically bring out all configurations
needed while dialing-up, by comparing the IMSI of the SIM card to the
record listed in the manufacturer’s database.
Note_1: You are highly recommended to select the Manual or APN
Profile List to specify the network for your subscription. Your ISP always
provides such network settings for the subscribers.
Note_2: If you select Auto-detection, it is likely to connect to improper
network, or failed to find a valid APN for your ISP.
APN
1. A Must filled setting
2. String format : any
text
Enter the APN you want to use to establish the connection.
This is a must-filled setting if you selected Manual-configuration as dial-
up profile scheme.
IP Type
1. A Must filled setting
2. By default IPv4 is
selected
Specify the IP type of the network service provided by your 3G/4G
network. It can be IPv4, IPv6, or IPv4/6.
PIN code
1. An Optional setting
2. String format :
integer
Enter the PIN (Personal Identification Number) code if it needs to unlock
your SIM card.
Dial Number,
Account,
Password
1. An Optional setting
2. String format : any
text
Enter the optional Dial Number, Account, and Password settings if your
ISP provided such settings to you.
Note: These settings are only displayed when Manual-configuration is
selected.
Authentication
1. A Must filled setting
2. By default Auto is
selected
Select PAP (Password Authentication Protocol) and use such protocol to
be authenticated with the carrier’s server.
Select CHAP (Challenge Handshake Authentication Protocol) and use such
protocol to be authenticated with the carrier’s server.
When Auto is selected, it means it will authenticate with the server
either PAP or CHAP.
IP Mode
1. A Must filled setting
2. By default Dynamic
IP is selected
When Dynamic IP is selected, it means it will get all IP configurations
from the carrier’s server and set to the device directly.
If you have specific application provided by the carrier, and want to set IP
configurations on your own, you can switch to Static IP mode and fill in
all parameters that required, such as IP address, subnet mask and
gateway.
Note: IP Subnet Mask is a must filled setting, and make sure you have
the right configuration. Otherwise, the connection may get issues.
Primary DNS
1. An Optional setting
2. String format : IP
address (IPv4 type)
Enter the IP address to change the primary DNS (Domain Name Server)
setting. If it is not filled-in, the server address is given by the carrier while
dialing-up.
Secondary DNS
1. An Optional setting
2. String format : IP
address (IPv4 type)
Enter the IP address to change the secondary DNS (Domain Name Server)
setting. If it is not filled-in, the server address is given by the carrier while
dialing-up.