Advantech ICR-1601 - Page 69

ICR-1601
69
WDS Hybrid Mode
For the WDS Hybrid mode, the device bridges all the wired LAN and WLAN clients to another WDS or
WDS hybrid enabled WiFi devices which the device associated with.
WDS Hybrid Mode
Item
Value setting
Description
Lazy Mode
The box is checked by
default.
Check the Enable box to activate this function.
With the function been enabled, the device can auto-learn WDS peers
without manually entering other AP’s MAC address. But at least one of the
APs has to fill remote AP MAC addresses.
Green AP
The box is unchecked
by default.
Check the Enable box to activate Green AP function.
VAP Isolation
The box is checked by
default.
Check the Enable box to activate this function.
By default, the box is checked; it means that stations which associated to
different VAPs cannot communicate with each other.
Time Schedule
A Must filled setting
Apply a specific Time Schedule to this rule; otherwise leave it as (0) Always.
If the dropdown list is empty ensure Time Schedule is pre-configured. Refer
to Object Definition > Scheduling > Configuration tab.
Scan Remote
AP’s MAC List
Available when Lazy
Mode disabled.
Press the Scan button to scan the spatial AP information, and then select one
from the AP list, the MAC of selected AP will be auto filled in the following
Remote AP MAC table.
Remote AP MAC
1~4
Available when Lazy
Mode disabled.
Enter the remote AP’s MAC manually, or via auto-scan approach, The device
will bridge the traffic to the remote AP when associated successfully.
By default, VAP 1 is enabled and security key is required to connect to the gateway wirelessly to
enhance the security level and prevent unexpected access of un-authorized devices.