Advantech LNC M5800 Series - Page 190

Milling Machine Series
Control panel operations
185
Advantech-LNC Technology Co., Ltd.
This key can be pressed to set the spindle's location. The <Reset> key can be pressed to cancel the setting.
2、
3、
4、
5、
6、
1.
2.
3.
4.
5.
8. COOL (cutting fluid)
This is the switch for controlling cutting coolant. The cutting coolant can be activated by pressing this key, and it can be
shut off by pressing this key again.
9. AIR BLOW (blowing air)
This is the switch for controlling the blow of air. Air blow can be started by pressing this key, and it can be turned off by
pressing this key again.
1.
2.
3.
4.
5.