Safety Instructions
1.
Read these safety instructions carefully.
2.
Keep this User Manual for later reference.
3.
Disconnect this
equipment from
any AC outlet before cleaning. Use a
damp cloth. Do not use liquid or spray detergents for cleaning.
4.
For plug-in equipment, the power outlet socket must be located near
the
equipment and must be easily accessible.
5.
Keep this equipment away
from humidity.
6.
Put this equipment on a reliable surface during installation.
Dropping it or
letting it fall may
cause
damage.
7.
The
openings
on the enclosure are for air convection. Protect the
equipment from overheating. DO NOT COVER THE OPENINGS.
8.
Make sure the voltage of
the power
source is correct
before
connecting the equipment to the power
outlet.
9.
Position the power cord so that people
cannot step on it. Do not place
anything over the power cord.
10.
All cautions and warnings on the equipment should be noted.
11 .
If the equipment is not used for a long time, disconnect it from the power
source to avoid damage by transient overvoltage.
12.
Never pour any liquid into an opening. This
may cause fire or electrical
shock.
13.
Never open
the equipment. For safety reasons, the equipment
should
be opened only by qualified service
personnel.
14.
If one of the following situations arises, get the equipment checked
by
service personnel:
15.
The
power cord or plug is damaged.
16.
Liquid
has penetrated into the
equipment.
17.
The
equipment has been exposed to moisture.
18.
The equipment does not work well,
or you cannot get it to work according
to the user's manual.
19.
The
equipment has been dropped and damaged.
20.
The equipment has obvious signs of breakage.
21. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT WHERE THE
STORAGE TEMPERATURE MAY GO BELOW -30° C (-22° F) OR ABOVE 70° C
(158° F). THIS COULD DAMAGE THE EQUIPMENT. THE EQUIPMENT
SHOULD BE IN A CONTROLLED ENVIRONMENT.
Operating temperature: 50° C
22.
CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY
REPLACED. REPLACE ONLY
WITH THE SAME OR EQUIVALENT
TYPE RECOMMENDED BY THE MANUFACTURER, DISCARD USED
BATTERIES ACCORDING TO THE MANUFACTURER'S
INSTRUCTIONS.
23.
The
sound pressure level
at the
operator's position according to IEC
704-1:1982
is no more than 70
dB (A).
DISCLAIMER:
This set of instructions
is given according to IEC 704-1.
Advantech disclaims all responsibility for the accuracy of any
statements
contained herein.
To Next Page
Loading...
Need help?
General