To check if the adapter is properly installed, you can right-click My Computer choose
Properties click Device Manager.
(For Widows XP) (For Widows 2000)
The Configuration Utility appears as an icon on the system tray of Windows while the
adapter is running. You can open the utility by double-click on the icon.
Right-click the icon, there are some items for you to operate the configuration utility,
Launch Config Utilities Select this option to open the Configuration Utility tool.
Use Zero Configuration as Configuration utility Select this option to use Windows
XP built-in wireless configuration utility (Windows Zero Configuration) to configure to
card.
Switch to AP Mode Select this option to change to AP mode.
Exit Select Exit to close the Configuration Utility tool.
To Next Page
Loading...
Need help?
General
