Need help?Do you have a question about the ADVANTEST R6552 Series and is the answer not in the manual?
General| Type | Digital Multimeter |
|---|---|
| Measurement Functions | DC Voltage, AC Voltage, DC Current, AC Current, Resistance, Frequency, Temperature, Capacitance |
| DC Voltage Range | 100 mV to 1000 V |
| AC Voltage Range | 100 mV to 750 V |
| DC Current Range | 100 µA to 10 A |
| AC Current Range | 100 µA to 10 A |
| Resistance Range | 100 Ω to 100 MΩ |
| Frequency Range | 10 Hz to 300 kHz |
| Temperature Range | -200°C to 1000.00 °C |
| Display | LCD |
| Interface | GPIB, RS-232 |
| Power Supply | 100 V to 240 V AC, 50/60 Hz |
| Weight | 3.5 kg |
Information on warning labels, including DANGER and CAUTION symbols and their meanings.
Essential safety guidelines for operating the instrument to prevent hazards.
Important safety precautions to follow before and during instrument operation.
Information regarding the instrument's power supply requirements and conditions.
Specifies the voltage and current limits for safe operation across various terminals.
Details on voltage, frequency, and power consumption requirements for the instrument.
Instructions for safely replacing the power and protection fuses.
Detailed explanation of the controls, buttons, and indicators on the instrument's front panel.
Explanation of the connectors and controls located on the rear panel of the instrument.
Describes the procedure and checks performed when powering on the instrument.
Instructions for performing AC voltage and AC+DC voltage measurements.
Procedure for conducting two-wire resistance measurements.
Guide on how to perform four-wire resistance measurements.
Instructions for measuring DC current using the instrument.
Procedure for measuring AC current and AC+DC current.
How to perform frequency measurements using the instrument.
Steps for measuring diodes with the instrument.
Guide for measuring ripple voltage on the R6552T-R model.
Operation and function of the BURST mode measurement.
Explanation of the LONG-IT measurement mode and its operation.
Overview of the seven calculation functions supported by the instrument.
Procedure for performing self-tests on the instrument.
Detailed guide on performing DC voltage measurements with the instrument.
Details on how to operate the instrument using the GPIB interface.
How to configure GPIB settings like header ON/OFF and address.
Details on operating the instrument using the RS-232 interface.
Instructions for configuring RS-232 communication parameters.
Outlines the necessary preparations before calibrating the instrument.
Step-by-step guide for calibrating the instrument using panel controls.
To Next Page