Adventuridge 718022 - Page 3

300cm
346.6cm
247.5cm
180cm
173.3cm
129.4cm
250cm
60cm
Page: 2
718022 5M Bell Tent instructions
Page: 3
718022 5M Bell Tent instructions
Centre pole (jointed) x 1 Door ‘A’ Frame (jointed) x 1 Rain cap x 1
Pegs x 24
Bell Tent Contents
Your Bell Tent comes with the following :
• 1 x Main Canvas (zipped to the groundsheet)
• 1 x Groundsheet.(zipped to the main canvas)
• 1 x Carry Bag
• 1 x Peg bag
• 24 x Steel pegs (shown below)
• 1 x Rain Cap (shown Below)
• 1 x Centre Pole (shown below)
• 1 x Door Pole (A frame - shown below)
Contents and Tools
Details on the contents of your bell Tent, plus tools required.
Tools Required and Recommended (not supplied with your tent)
The only tool you will need to pitch your tent is a hammer, the type of hammer is down to your personal
preference, but we recommend using a wooden mallet style of hammer as this can make it easier to drive your
steel pegs into the ground and the wooden head causes less damage to your steel pegs.
We would also recommend the use of a peg puller to help pull the pegs out of the ground. Whilst not required
this can make it easier to pull the pegs out of the ground particularly when the ground is hard.