Adventys Induct-NoLimit MO4NL 16000 - Troubleshooting and Error Codes; Specific Message Display Codes

38

The device is perfectly secure. It constantly monitors temperature values and several other electrical pa-
rameters to guarantee the user the highest level of performance and safety at all mes.
If during use an incorrect operang status is detected, there may be forced shutdown of the device with
the indicaon on the power level display, a ashing error code "Fx" or " hx ".
The dierent codes managed by the device are listed in the table below.


- 
- 
- 
 
- 
 
 
 
 
 
 
The ashing error code is displayed as long as the user has not stopped the unit himself and has not res-
tarted a new start, by using the SELECTION / ON key of the relevant replace.
If an error code remains permanently displayed despite several successive acknowledgment aempts,
contact the service department.
If error code F8 is displayed when the generator block is turned on, it indicates a problem with the fans.
Either there is no connecon (absence) of 1 or more fans, or there is reverse polarity, or there is overcon-
sumpon. You should contact the aer-sales service and report error F8.
Pending the verdict of the manufacturer, the user has the opportunity to inhibit the error F8 and use the
product in a degraded mode, unl the complete correcon of the problem.
EN