AEB 551 - Technical Specifications; Safety Device Function; General Direction; Installation Position and Wiring

To Next Page

To Previous Page

IS551-0 REV. 081105-0

5 - 12

EnglishEnglish

English

Technical SpecificationsTechnical Specifications

Technical Specifications

General DirectionGeneral Direction

General Direction

We advise you to fix the

Safety Car Safety Car

Safety Car in a vertical position, away

from possible water infiltrations and excessive heat sources ( for

example: exhaust manifolds), so as to avoid to irreparably damage

the Emulator.

To avoid bad workings of the

Safety CarSafety Car

Safety Car we advise you to pass the

wires away from the high tension wire;

- make good connections.

Please, pay attention that the best Please, pay attention that the best

Please, pay attention that the best

connection you can do is a duly insulated welding.connection you can do is a duly insulated welding.

connection you can do is a duly insulated welding.

Do not absolutely open the

Safety CarSafety Car

Safety Car box, especially when the

engine is running or the board panel is inserted.

A.E.B. srl declinesA.E.B. srl declines

A.E.B. srl declines

every responsabilities for damages caused to things orevery responsabilities for damages caused to things or

every responsabilities for damages caused to things or

person which derive from the tampering of its own deviceperson which derive from the tampering of its own device

person which derive from the tampering of its own device

provoked by unauthorized persons.provoked by unauthorized persons.

provoked by unauthorized persons.

SAFETY DEVICESAFETY DEVICE

SAFETY DEVICE

The safety car, enables the GAS solenoid valves only with the engine running.

This means that if the engine was accidentally stopped, the GAS supply would

automatically be cut off.