EasyManua.ls Logo

AEE Toruk AP10 Quick Start Guide

AEE Toruk AP10
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Remote control and Wi-Fi Repeater Description
Remote control
(U.S. Mode)
UP
UP
LEFT
LEFT
FORWARD
FORWARD
LEFT
TURN
LEFT
TURN
TURN
RIGHT
TURN
RIGHT
RIGHT
RIGHT
BACK
BACK
DOWN
DOWN
Quadcopter Direction
(" " indicates nose direction)
10
Taking off and Landing(Outdoors)
Taking off
Landing
1) Place Quadcopter (with full power battery) on a flat and open ground, and ensure Tail Indicator faces toward you.
2) Power on the Remote control,Wi-Fi Repeater and Quadcopter in sequence.
3) Be sure the Remote control is set exactly as the figure below.
4) Starting motors: toggle the left joysticks to left bottom corner and toggle right joystick to right bottom corner at the mean time to start motors. Once the motors
start please release the joysticks immediately.
5) Push the left joystick slowly, then Quadcopter take off. Please refer AEE Quadcopter User Manual for more details.
Note: The motors can not be started until GPS signal is ready(Tail Indicator will alternate between fast blinking and on).
S1 S2
NULL
S3 S4
GPS
NRM
1) Slowly pull the left joystick to lower Quadcopter until it touches the ground(only on flat and open ground).
2) After landing, pull the left joystick to the lowest position and hold for more than 3 seconds until the motors stop.
3) Power off Quadcopter by sliding the switch to OFF.
4) Remove the battery.
5) Power off Remote control and Wi-Fi Repeater.
Important:
1) Control the flight height under your control during your first flight.
2) Do not stop the motors during flight, or it will cause the Quadcopter to drop without control.
S1 S2
NULL
S3 S4
GPS
NRM
[ 1 ] Propeller [ 2 ] Motor [ 3 ] Front Indicator [ 4 ] Camera
[ 5 ] Landing Gear [ 6 ] Micro SD card [ 7 ] Quadcopter Battery [ 8 ] Tail Indicator
[ 9 ] Power switch [ 10 ] Rear Indicator [ 11 ] Battery Level LCD Segment Display
[ 12 ] Battery Level Check button
Note: The Remote control is set to U.S. mode by default.
Antenna
Wi-Fi Repeater
Repeater Base
Smartphone Holder
3-position Switch S2
3-position Switch S1
Remote control
Power Indicator
Capture Indicator
Left Joystick
Airborne
Shutter Button
Airborne Video
Recording Button
Camera Angle Control S3
3-position Switch S4
Video Indicator
Strap Hole
Right Joystick
Video Stop Button
Battery
Compartment
Remote control Power
Switch
Power Switch
Charging Port
(mini USB port)
Pairing Button
Repeater Base
Power Indicator
Wi-Fi Indicator
Lock Screw
Disclaimer
Please read this disclaimer carefully before using the product of Quadcopter. This product is not suitable for people under the age of 18. By using this
product, you hereby agree to this disclaimer and signify that you have read them fully. You agree that you are responsible for your own conduct and
content while using this product, and for any consequences there of. You agree to use this product only for purposes that are proper and in accordance
with the terms and any applicable or guidelines AEE may make available.
1. Any part of this disclaimer is subject to change without prior notice; refer to HYPERLINK www.aee.com for the latest version.
2. AEE Technology reserves the right of final interpretation of this disclaimer.
3. This disclaimer is made in various language versions; in the event of divergence among different versions, Chinese version shall prevail.
[ 1 ]
[ 2 ]
[ 3 ]
[ 4 ]
[ 5 ]
[ 7 ]
[ 6 ]
[ 8 ]
[ 9 ]
[11]
[10]
[12]
middle

Other manuals for AEE Toruk AP10

Question and Answer IconNeed help?

Do you have a question about the AEE Toruk AP10 and is the answer not in the manual?

AEE Toruk AP10 Specifications

General IconGeneral
Weight1.2 kg
Weight (Including Battery & Propellers)1.5 kg
Flight Time25 minutes
Max Ascent Speed5 m/s
Gimbal3-axis
GPSYes
Obstacle AvoidanceNo
Follow Me ModeYes
BatteryLiPo 3S
Operating Temperature-10 to 40 °C
Charging Time120 minutes

Related product manuals