Need help?Do you have a question about the AEG Electrolux LAVAMAT 11842 VIT and is the answer not in the manual?
General| Maximum spin speed | 1400 RPM |
|---|---|
| Spin Speed | 1400 rpm |
| Noise Level (Spinning) | 74 dB |
| Water Consumption | 52 L |
| Color | White |
| Loading type | Front loading |
| Programs | Delicates, Handwash, Wool, Jeans |
| Dimensions (H x W x D) | 850 x 600 x 600 mm |
Important safety notes and checks before the initial operation of the appliance.
General precautions and warnings for safe operation and to avoid damage to the appliance.
Procedures for unpacking, checking for damage, and removing transit bolts before installation.
Explanation of the child safety lock feature and how to activate/deactivate it.
Steps for initial setup, including connection checks and running a first cleaning cycle.
Information on recommended load sizes for drying cottons and synthetics.
How to select a drying programme using the programme selector dial.
How to select the drying time using button 6, with notes on time adjustments and uniform drying.
Guidelines for using the automatic washing and drying (NON-STOP) programmes, including load sizes.
How to select both washing and drying programmes and set options for combined cycles.
Table providing suggested drying times based on fabric type, load size, and desired dryness.
Essential steps for dryer operation, including water tap and drain hose setup, and load reduction.
Important safety note to disconnect the appliance before cleaning or maintenance.
Procedure for draining the appliance to prevent damage from freezing temperatures below 0°C.
Common causes and solutions for the washer-dryer not starting, including door closure, power, and delay start issues.
Troubleshooting steps for when the machine fails to fill with water, checking tap, hose, and filter.
Troubleshooting for issues with emptying or spinning, including programme selection and load distribution.
Causes and solutions for poor washing results, such as detergent issues, temperature, and load size.
Reasons why the door may not open and how to resolve them, including programme status and water presence.
Troubleshooting excessive vibration or noise, related to transit bolts, levelling, and load distribution.
Causes for late or absent spinning, including unbalance detection and load issues.
Troubleshooting why the machine is not drying or drying properly, checking time, water tap, and load.
Detailed steps for unpacking the machine, removing packaging, transit devices, and polystyrene base.
Instructions for removing all rear transit bolts, brackets, and plastic spacers to prepare for installation.
Procedure for filling holes with plug caps and connecting the water inlet hose.
Guidance on placing the machine on a flat floor, ensuring air circulation, and levelling using adjustable feet.
Instructions for connecting the appliance to a cold water supply, including hose placement and tightening.
How to connect the water inlet hose to a standard 3/4" threaded tap, noting pressure requirements.
Methods for positioning the drain hose, including sink edge, drain pipe branch, and direct drain pipe.
Guidelines for electrical connection, checking installation capacity, earthing, and accessibility of the power cable.
Requirements for a permanent connection, including a double pole switch and qualified electrician.
To Next Page
