Problem Possible cause Solution
Temperature cannot be set. The Frostmatic function is
switched on.
Switch off Frostmatic func‐
tion manually, or wait until
the function deactivates au‐
tomatically to set the temper‐
ature. Refer to "Frostmatic
function" section.
The temperature in the appli‐
ance is too low/too high.
The temperature is not set
correctly.
Set a higher/lower tempera‐
ture.
The door is not closed cor‐
rectly.
Refer to "Closing the door"
section.
The food products' tempera‐
ture is too high.
Let the food products tem‐
perature decrease to room
temperature before storage.
Many food products are stor‐
ed at the same time.
Store less food products at
the same time.
The door has been opened
often.
Open the door only if neces‐
sary.
The Frostmatic function is
switched on.
Refer to "Frostmatic func‐
tion" section.
There is no cold air circula‐
tion in the appliance.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
tips" chapter.
DEMO appears on the dis‐
play.
The appliance is in the dem‐
onstration mode.
To exit the demonstration
mode, press and hold the
OK button for approximately
10 seconds until you hear a
long sound and the display
turns off for a short time.
A or or symbol is
shown instead of numbers
on the temperature display.
Temperature sensor prob‐
lem.
Contact the nearest Author‐
ized Service Centre. The
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
8.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to installation instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
www.aeg.com16
To Next Page
Loading...
Need help?
General
