AEG BPE742220M - Page 44

Problem Possible cause Remedy
The oven does not heat up. The fuse is blown. Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
The lamp does not operate. The lamp is defective. Replace the lamp.
The food sensor does not
operate.
The plug of the food sensor
is not correctly installed into
the socket.
Put the plug of the food sen‐
sor as far as possible into
the socket.
The display shows F111. The plug of the food sensor
is not correctly installed into
the socket.
Put the plug of the food sen‐
sor as far as possible into
the socket.
The display shows an error
code that is not in this table.
There is an electrical fault. • Turn off the oven with the
house fuse or the safety
switch in the fuse box
and turn it on again.
• If the display shows the
error code again, contact
the Customer Care De‐
partment.
Steam and condensation
settle on the food and in the
cavity of the oven.
You left the dish in the oven
for too long.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
The demo mode is activated. Refer to "Daily Use chapter,
Basic Settings.
13.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service
centre is on the rating plate. The rating
plate is on the front frame of the oven
cavity. Do not remove the rating plate
from the oven cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
www.aeg.com44