Components
Description
Remedy
The lamp is burnt out. Replace the lamp, for details refer to "Care and Clean‐
ing" chapter, How to replace: Lamp.
Power cut always stops cleaning. Repeat
cleaning if it's interrupted by power failure.
Problems with Wi-Fi signal
Possible cause
Remedy
Trouble with wireless network signal. Check if your mobile device is connected to the wire‐
less network.
Check your wireless network and router.
Restart the router.
New router installed or router configuration changed. To configure appliance and mobile device again, refer
to "Before first use" chapter, Wireless connection.
The wireless network signal is weak. Move router as close to the appliance as possible.
The wireless signal is disrupted by another microwave
oven placed near the appliance.
Turn off the microwave oven.
Avoid using another microwave oven and the Remote
Control of the appliance at the same time. Microwaves
disrupt Wi-Fi signal.
12.2 How to manage: Error codes
When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description Remedy
C2 - the Food sensor is in the appliance cavity during
Pyrolytic Cleaning.
Take out the Food sensor.
C3 - the door is not fully closed during Pyrolytic Clean‐
ing.
Close the door.
F111 - Food sensor is not correctly inserted into the
socket.
Fully plug Food sensor into the socket.
F240, F439 - the touch fields on the display do not
work properly.
Clean the surface of the display. Make sure there is no
dirt on the touch fields.
F601 - there is a problem with Wi-Fi signal. Check your network connection. Refer to "Before first
use" chapter, Wireless connection.
32 ENGLISH
To Next Page
Loading...
