AEG Competence 32081 B - Shelf Supports

28
Cleaning the fat filter
The fat filter should be cleaned after every use. The filter may be washed in a dishwasher on
a65 °C wash. ifthe filter is heavily soiled, place the filter in a saucepan of water with approxi-
mately 1 tsp of automatic washing powder or dishwasher powder. Bring to the boil and
leave to soak for approximately 30 minutes or longer depending on the degree of soiling.
Ensure the solution does not boil over as it could mark your hob. Rinse filter in clear water
and dry.
Care of liners (Optional extra)
The secondary oven has a catalytic roof.
The catalytic liners are self Cleaning and will destroy splashes of food and fats while the oven
is on. To aid this process and to ensure continued good performance of the liners, we re-
commend you run the oven, without food, once a week at 250 °C for at least 1 hour.
Important:
The steam cleaning process recommended for enamelled ovens must not be carried out if
catalytic liners are fitted.
Manual cleaning of the catalytic liners is not recommended. Damage will occur if oven
sprays or abrasives of any kind are used.
Slight discoloration of the Catalytic surfaces may occur in time. This does not affect the Cat-
alytic properties in any way.
Additional Catalytic panels are available as an optional extra, please consult the AEG price
list.
Shelf supports
The shelf supports can be removed to clean the side walls of the oven (refer to diagram).
Hold the shelf support at the bottom, lift up towards the centre of the oven and unhook at
the top. Reverse the procedure to fit.
RP805 10/96 UK-RP810 10/96 UK-RP802-1 10/96 UK