EasyManua.ls Logo

AEG DBB5660HM - Controls; Control Panel and Speed Selection; Filter Saturation Controls

AEG DBB5660HM
192 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.aeg.com
6
5. CONTROLS
The hood is tted with a control panel with
aspiration speed selection control and a
light switch to control cooking area lights.
Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes prior to cooking
and to leave in operation during cooking
and for another 15 minutes approximately
after terminating cooking.
The control switches are located on the
unit’s front panel:
T6
1 T2 T3 T4 T5 T6 T7 T8 T9
2 3 4 5 6 7 8 9
1 Speed ON/OFF button
Control panel on/off key
2 Suction speed (power) key 1:
3 Suction speed (power) key 2:
4 Suction speed (power) key 3:
5 Suction speed (power) key 4:
Note: suction speed (power) key 4 has
a limited duration of 5 minutes, after
which the previous suction speed is
reactivated.
6 "Breeze" function key
(Room ventilation)
The hood switches on at low suction
speed (power) for 60 minutes, after
which it switches off.
7 Filter saturation control and
activation/deactivation key
8 Hob2
H
ood function indicator
9 Lights ON/OFF key
Control panel on/off function
With the hood in standby, press key 1 , all
led lights will switch off: the control panel
is off.
Press key 1 again, all led lights will turn
on: the control panel is active.
Carbon lter saturation control activation/
deactivation function
With the hood in standby, press key 5 for
longer than 3 seconds
Key 7 will ash to indicate that the carbon
saturation lter has been activated.
Key 7 will remain lit to indicate that
the carbon saturation lter has been
deactivated.
Filter saturation control and reset
function
At regular intervals and depending on
the hood temperature, key 7 lights
up to indicate that the lters need to
be maintained in accordance with the
instructions in the relative paragraphs.
Key 7 on with a xed light: maintenance is
required on the grease lters
Key 7 on and ashing: maintenance is
required on the carbon lter.
Filter saturation indicator reset
With the hood in standby, press key 7 for
longer than 3 seconds.
Repeat the operation if necessary.
preciz.hu

Related product manuals