EasyManua.ls Logo

AEG DUB2610W - Maintenance; Grease Filter Cleaning; Charcoal Filter

AEG DUB2610W
128 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.aeg.com
4
4.1 
be cleaned once a month using non
aggressive detergents, either by hand or
in the dishwasher, which must be set to a
low temperature and a short cycle. When

may discolour slightly, but this does not

4.2  - 
The saturation of the

prolonged use, depending on the type of
cooking and the regularity of cleaning of the

In any case it is necessary to replace the
cartridge at least every four mounths.

regenerated.
Warning! Power cable replacement
must be undertaken by the authorised
service assistance centre or similar

The minimum distance between the
supporting surface for the cooking
equipment on the hob and the lowest part
of the range hood must be not less than
50cm from electric cookers and 65cm from
gas or mixed cookers. If the instructions for
installation for the gas hob specify a greater
distance, this must be adhered to.
4. MAINTENANCE
ATTENTION! Before performing any
maintenance operation, isolate the
hood from the electrical supply by
switching off at the connector and
removing the connector fuse.
Or if the appliance has been connected
through a plug and socket, then the plug
must be removed from the socket.
The cooker hood should be cleaned

with which you carry out maintenance of the

using the cloth dampened with neutral liquid
detergent. Do not use abrasive products.
DO NOT USE ALCOHOL!
Warning! Failure to carry out the basic
cleaning recommendations of the
cooker hood and replacement of the

we recommend observing these
instructions.
The manufacturer declines all responsibility
for any damage to the motor or any

maintenance or failure to observe the above
safety recommendations.
Downloaded from www.vandenborre.be

Related product manuals