Problem and alarm code Possible cause and solution
Technical malfunction of the appli‐
ance.
The display shows iC0 or iC3.
• Switch the appliance off and on.
The level of water inside the appli‐
ance is too high.
The display shows iF1.
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the right height above the
floor. Refer to the installation instructions.
The appliance stops and starts
more times during operation.
• It is normal. It provides optimal cleaning results and energy savings.
The programme lasts too long.
• If the delay start option is set, cancel the delay setting or wait for the
end of the countdown.
• Activating options increases the programme duration.
The displayed programme duration
is different than the duration in the
consumption values table.
• Refer to the consumption values table in the chapter "Programme se‐
lection".
The remaining time in the display in‐
creases and skips nearly to the end
of the programme duration.
• This is not a defect. The appliance is working correctly.
Small leak from the appliance door.
• The appliance is not levelled. Loosen or tighten the adjustable feet (if
applicable).
• The appliance door is not centred on the tub. Adjust the rear foot (if ap‐
plicable).
The appliance door is difficult to
close.
• The appliance is not levelled. Loosen or tighten the adjustable feet (if
applicable).
• Parts of the tableware are protruding from the baskets.
The appliance door opens during
the wash cycle.
• The AirDry function is activated. You can deactivate the function. Refer
to "Basic settings".
Rattling or knocking sounds from
the inside of the appliance.
• The tableware is not properly arranged in the baskets. Refer to basket
loading leaflet.
• Make sure that the spray arms can rotate freely.
The appliance trips the circuit-beak‐
er.
• The amperage is insufficient to supply simultaneously all the applian‐
ces in use. Check the socket amperage and the capacity of the meter
or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact an Authorised Service
Centre.
Once you have checked the appliance,
deactivate and activate the appliance. If the
problem occurs again, contact an Authorised
Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.
WARNING!
We do not recommend using the
appliance until the problem has been
completely fixed. Unplug the appliance
and do not plug it in again until you are
certain that it operates correctly.
52 ENGLISH
To Next Page
Loading...
