AEG FSE75768P - Page 20

It is not possible to activate
or deactivate options while a
programme is running.
Not all options are
compatible with each other.
Activating options often
increases the water and
energy consumption as well
as the programme duration.
9.5 How to start the AUTO
Sense program
1. Press .
• The light related to the button is
on.
• The display shows the longest
possible program duration.
2. Close the appliance door to start the
program.
The appliance senses the type of load
and adjusts a suitable wash cycle.
During the cycle, the sensors operate
several times and the initial program
duration can decrease.
9.6 How to delay the start of a
programme
1. Select a programme.
2. Double press .
The display shows 1h.
3. Press repeatedly until the display
shows the desired delay time (from 1
to 24 hours).
4. Close the appliance door to start the
countdown.
When you set the delay start, the remote
start is automatically activated.
During the countdown, you cannot
change the programme selection. You
can change the delay time in the app.
When the countdown is complete, the
programme starts.
9.7 How to cancel the delay
start while the countdown
operates
Press and hold for about 3 seconds.
The appliance returns to the programme
selection.
If you cancel the delay start,
you have to select the
programme again.
9.8 How to cancel a running
programme
Press and hold for about 3 seconds.
The appliance returns to the programme
selection.
Make sure that there is
detergent in the detergent
dispenser before you start a
new programme.
9.9 Opening the door while
the appliance operates
Opening the door while a programme is
running pauses the wash cycle. The
display shows the remaining duration of
the programme. After closing the door,
the wash cycle resumes from the point of
interruption.
Opening the door while the remote start
is activated deactivates this function.
Activate the remote start again before
you close the door; otherwise, the wash
cycle starts immediately after you close
the door. Opening the door does not
deactivate the remote start if the delay
start is set.
If you open the door during the delay
start countdown, the countdown is
paused. The display shows the current
countdown status. After closing the door,
the countdown resumes.
Opening the door while the
appliance operates may
affect the energy
consumption and the
programme duration.
www.aeg.com20