EasyManua.ls Logo

AEG FSK93800P - Page 22

AEG FSK93800P
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Problem Possible cause and solution
The programme does not
start.
Make sure that the appliance door is closed.
Press .
If the delay start is set, cancel the setting or wait for the
end of the countdown.
The appliance recharges the resin inside the water soft-
ener. The duration of the procedure is approximately 5
minutes.
The appliance does not fill
with water.
The display shows the mes-
sage: Appliance is not fill-
ing water. (机器目前没有加
水。)
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
The appliance does not
drain the water.
The display shows the mes-
sage: Appliance is not
draining water. (机器目前没
有排水。)
Make sure that the sink spigot is not clogged.
Make sure that the filter in the outlet hose is not clog-
ged.
Make sure that the interior filter system is not clogged.
Make sure that the drain hose has no kinks or bends.
The anti-flood device is on.
The display shows the mes-
sage: Appliance is flooding
or has an error in the wa-
ter inlet. (机器正在溢水或
水口处发生故障。)
Close the water tap and contact an Authorised Service
Centre.
The appliance stops and
starts more times during op-
eration.
It is normal. It provides optimal cleaning results and en-
ergy savings.
The programme lasts to
long.
If the delay start is set, cancel the delay setting or wait
for the end of the countdown.
Activate the TimeSaver option to reduce the pro-
gramme duration.
Activating options can increase the programme dura-
tion.
The remaining time in the
display increases and skips
nearly to the end of the pro-
gramme duration.
This is not a defect. The appliance is working correctly.
Small leak from the appli-
ance door.
The appliance is not levelled. Loosen or tighten the ad-
justable feet (if applicable).
The appliance door is not centred on the tub. Adjust the
rear foot (if applicable).
www.aeg.com22

Related product manuals