7.3 FlexiBridge Big Bridge
mode
To activate the mode press until you
see the correct mode indicator . This
mode connects three rear sections into
one cooking zone. The one front section
is not connected and operates as a
separate cooking zone. You can set the
heat setting for each zone separately.
Use two left side control bars.
Correct cookware position:
To use this mode you have to place the
cookware on the three connected
sections. If you use cookware smaller
than two sections the display shows
and after 2 minutes the zone switches off.
Incorrect cookware position:
7.4 FlexiBridge Max Bridge
mode
To activate the mode press until you
see the correct mode indicator . This
mode connects all sections into one
cooking zone. To set the heat setting use
any of the two control bars on the left
side.
Correct cookware position:
To use this mode you have to place the
cookware on the four connected
sections. If you use cookware smaller
than three sections the display shows
and after 2 minutes the zone switches off.
Incorrect cookware position:
www.aeg.com
16
To Next Page
Loading...
